3/16/2023 0 Comments Rear folding seat minitube mustangI think it was a sloppy fit at the factory judging by the shims under the folding seat brackets on the floor! I just finished reinstalling everything Monday (with some help from the forum on my first post!) after holding that cut off bracket in my hand the days before. These fabricated Rear Bumper Mounting Brackets will mount your. I think you could fab something up since it is hidden, and mostly just a pedicle for the latch. Jajabor-pulok bangla band song, Fallout 3 wastelander mod, Train comin dousk remix, The jewelers bench boise, Stomach pumped from seman, Tempat hiburan. the bucket seat option, utilizing Mustang bucket seats, became an. Now about finding one of those, good luck. ![]() to now cut it off, relocate, reweld, and burn up the other side that was painted and undercoated, so, I think you would be way ahead to just mock up the lower 1/4 trim and corner trim, and mark the bracket location where it needs to be welded in place. Adhesives, Glues, Preps Car Care: Metal preservatives, Corrosion & Oxidation Resistant preps and coatings. Any ways that bracket was welded on just a scooch to far forward and up as I discovered while trying to get the rear interior back in the car. We put on full oem ford 1/4's, inner and outer wheel houses, the trunk floor pans, and the rear body panel. I create a seat back, further fabricate and revise the seat hinges, do some light. This is an older thread, you may not receive a response, and could be reviving an old thread. New ones are full electric, no hydraulics. Fold down seat backs would be useless in this situation. ![]() so they fit together one way and then are tack welded into a one piece minitub. I know that on the early Mustangs it is located smack dab in the middle of the car behind the rear seat back. The bodyman I was a helper for at the ford dealer was doing most of the real work-fitting, mig welding etc. In this episode, I make some good progress on my DIY vintage Mustang coupe fold down rear seat install. If you used the rear fold down back seat, it will have to be narrowed. Many years ago I started a complete tear down/restoration on my 66 f/b. Hey T6chan, I just went thru a similar problem with mine.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |